How to adjust welding defects of welding robots

Release time:

2024-10-05

　　So how to adjust the welding defects of welding robots?

　　1、 After cooling, an arc pit is formed, and the function of submerging the arc pit is added to the operation steps during programming to fill it.

　　2、 Excessive splashing may be caused by improper selection of welding parameters, gas composition, or excessive external elongation of the welding wire. The power can be adjusted to change welding parameters, the gas proportioner can be adjusted to adjust the proportion of mixed gas, and the relative direction of the welding gun and workpiece can be adjusted.

　　3、 The occurrence of undercutting may be due to improper selection of welding parameters, incorrect viewpoint of the welding gun, or orientation of the welding gun. The power can be adjusted appropriately to change the welding parameters, the posture of the welding gun, and the relative direction of the welding gun. The welding gun and workpiece can be adjusted.

　　4、 Pores may be caused by poor gas maintenance, thick primer on the workpiece, or insufficient gas tightness during maintenance. Corresponding adjustments can be made.

　　5、 Welding deviation may be caused by incorrect welding direction or problems encountered when searching for the welding gun. At this point, please consider whether the center point of the welding gun is correct and make adjustments. If this situation occurs frequently, please check the zero position of each axis of the welding robot and perform calibration after zero position calibration.

PRE

How welding robots maintain precision welding

Precautions for welding robots after shutdown

Application of 3D flexible wel

2024-11-19

The three-dimensional flexible welding platform achieves precise welding of comp

Learn More +

What kind of workpiece is suit

2024-10-05

Firstly, the workpiece standardization robot follows a fixed route, and if the workpiece is not standardized, the robot will weld off center.

Learn More +

What are the types of welding

2024-10-05

Pneumatic driven welding robot for switch control and secondary control. Due to the lower viscosity of compressed air, pneumatic transmission is easier to achie...

Learn More +

Promote welding and cutting automation related technologies.

✓ Reply Within 24 Hours

✓ Site Commissioning

✓ Customer Service Staff Provide Attentive Service

✓ OFFICIAL Website: www.xbznjx.com